Tonight I replaced my 3D Printer nozzle with a 0.4mm nozzle instead of the 0.3mm it had on there and the flow is so much better, so now it's back in operation. I also hooked up my Octo-Power Box and got that working through voice commands and I set up my windows computer to remote start up and shut down and enabled voice commands for that too. That one was harder because I could only find one example that was close, but I was able to get it figured out so that voice worked too. I got the LED strip control I built put up and functioning. I had to re-solder the ESP8266 chip because the flux was conducting and needed to be cleaned and I had a couple surface mount resistors that came loose on the strip that I fixed easily.