Since I now have my 3D printer working, I decided to finish designing the camera adapter for my car. Unfortunately it's getting late, so I will need to wait for another day to actually print it off. It's very possible that I'll need to print it off multiple times while making adjustments in between, but that's the nature of prototyping. Fortunately I made it quite easy to make any adjustments just by changing a few parameters. After I get it all worked out, I may throw it up on Thingiverse in case somebody else with a similar car runs into the same issue.

While I was looking back at some older entries, I realized that I forgot to mention that I did end up replacing the stepper motor for the X-Axis shortly after that post.

Oh, and the circuit boards for the calculator are finished and should arrive her in a couple days. Then I can finish up the hardware part on that project.