So here's a quick update. I finished the circuit board and got all of the parts soldered on, but it didn't work correctly. While trying to fix it, I ended up burning some of the solder pads off. So I'm working on making a new one and using what I've learned from the first one, I'm going to make it better. I had taken some pictures while working on the first board, but my memory card went bad, so I lost all of the photos. So I'll try to take more pictures as I make the new board. So far, I've cut it out, scrubbed it, made a cardboard cutout (which required gluing 2 pieces of cardboard together) to help feed it through the laminator and made some alignment holes that I can stick pins through, that will end up acting as pilot holes for the main drill holes in the board. This should not only help me with getting the doube sided board aligned, but also holding the paper in place for me to tape onto the cardboard. Anyways, that's it for the update.